just in front of the handle bars on the main wiring harness there is a matching plug, plug it in.Ĭonnect wires to battery, turn key on and test and see if it works. On the control wiring you just ran about in the middle there is a 2 wire plug with black and orange wire on it. Route the contol wires down the handle bars and down through the hole in front of the handle bars and route it to the plug on the soleniod. one front, over radiator, then the glove box then the one in front of the handle bars. Remove the six black quick pins on the black center body plastic. small black plate and screw go on the back to hold the switch in. make sure the writing on the switch is where you can read it normally when on the seat. mount the switch housing on the left control, push the switch into the housing. Again match the color on the solenoid and winch terminal yellow go's on the green terminals, blue go's on blue.Ĭontrol wiring. hook these up last!!!!! they go to the red and black terminals on the soleniod. They go to the battery, Red to positive black to neg. the factory screws are to short to attach the new accessory switch mount. you will use two of the screw to replace the screws that are there. one of the housing will match the contour of the bottom of your left hand switch assy. In the kit IF it's the right one for the bike there should be two plastic switch housing and 4 black long screws. there are holes already drilled for it to mount to. it's located mid way up the side of the radiator and runs forward to the bumper. If it's a late model Arctic Cat ATV the soleniod is going to mount to the inside of the right front bumper support. First off when you ask a question like this it's a good idea to tell us which bike you are working on!!!!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |